3. As shown in the figure, an air wedge is used to measure the diameter of the thin wire. If l =589.3 nm, L = 2.888X10-2 m, the general width of 30

Solved 9. 120 pts] A thin metallic wire of thermal

Numerical problems based on wedge shaped film

A hydro pole is supported by two wires on opposite sides. At the top of the pole, wires form an angle of 64°. On the ground, the ends of the wires are

3. As shown in the figure, an air wedge is used to measure the diameter of the thin wire. If l =589.3 nm, L = 2.888X10-2 m, the general width of 30

A tube has 25mm outside diameter and an axial tensile load of 40 kN. If the strain on the tube is limited to 0.1% and density of 7800kg/m^3, what is the maximum

Two glass plates enclose a wedge-shaped air film, touching at one edge and are separated by a wire of 0.04 mm - Sarthaks eConnect

A wedge-shaped film of air is produced by placing a fine wire of diame

AIR WEDGE EXPERIMENT - THICKNESS OF A THIN WIRE

A tube has 25mm outside diameter and an axial tensile load of 40 kN. If the strain on the tube is limited to 0.1% and density of 7800kg/m^3, what is the maximum